Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 664
300 020 0x3014
T1 time-out for receiving a fax The other end machine cut
off the line, or the modular
cable get disconnected
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and ask the sender
to resend the fax.
*3 Receiving failure 50H: Forced stop Receiving a fax job is
finished
300 021 0x3015
T5 time-out The other end machine
runs out of paper or the
memory is full
Confirm the condition of
the other end machine,
and try the failed
operation.
*3 Transmitting failure 50H: Forced stop Receiving a fax job is
finished
300 022 0x3016
Carrier cut off The other end machine cut
off the line, or the modular
cable get disconnected
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and ask the sender
to resend the fax.
*3 Receiving failure 50H: Forced stop Receiving a fax job is
finished
300 023 0x3017
The product received an illegal frame in ECM Not used --- --- --- --- ---
300 024 0x3018
CTC/EOR resending over Line quality is not good Try the operation again *3 Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 025 0x3019
Not for the operator (for RX and communication
reservation)
Not used --- --- --- --- ---
300 026 0x301A
Time-out between frames in ECM Not used --- --- --- --- ---
300 027 0x301B
PIN reception (except EOR) Line quality is not good Try the operation again *3 Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 028 0x301C
The product could not detect EOL within 13 seconds
(default time) when receiving image data in G3 mode.
Line quality is not good,
or there is something
wrong with the other end
machine
Confirm the condition of
the other end machine,
and ask to resend the fax.
*3 Receiving failure 50H: Forced stop Receiving a fax job is
finished
300 029 0x301D
The product failed to detect dial tones before starting
dialing
The line type setting is
wrong, or the line is
disconnected
Correct the line type
setting. Connect the line
properly.
External error code 50H: Forced stop Transmitting a fax is finished
300 030 0x301E
The product failed to detect the second dial tones
before starting dialing
Not used --- --- --- --- ---
300 031 0x301F
The product detected busy tones before starting dialing
(BT1)
Not used --- --- --- --- ---
300 032 0x3020
The product detected busy tones before starting dialing
(BT2)
Not used --- --- --- --- ---
300 033 0x3021
The product failed to detect the second dial tones
during dialing operation
Not used --- --- --- --- ---
Table 7-23. Operator Call Error
External
error code
Internal
Code
Description Cause Remedies
Panel
Display
(reference)
Report Display
Trigger for
Stopping
Operation
Notification Message
MAIN SUB
manuals4you.commanuals4you.com

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English