Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 665
300 034 0x3022
The product detected busy tones during dialing
operation (BT1)
Not used --- --- --- --- ---
300 035 0x3023
The product detected busy tones during dialing
operation (BT2)
Not used --- --- --- --- ---
300 036 0x3024
The product failed to detect dial tones during dialing
operation
Not used --- --- --- --- ---
300 037 0x3025
The product failed to detect dial tones after dialing Not used --- --- --- --- ---
300 038 0x3026
The product detected busy tones after dialing (BT1) Not used --- --- --- --- ---
300 039 0x3027
The product detected busy tones after dialing (BT2) Not used --- --- --- --- ---
300 040 0x3028
The product received no reply from the other end
machine after dialing
Not used --- --- --- --- ---
300 041 0x3029
The product detected off-hook condition while making
auto dialing
Not used --- --- --- --- ---
300 042 0x302A
The product could not detect line current Not used --- --- --- --- ---
300 043 0x302B
The product could not detect the polarity Not used --- --- --- --- ---
300 044 0x302C
The other end machine backed to ready status from
busy status which was detected by busy tones while
ringing
Not used --- --- --- --- ---
300 045 0x302D
The other end machine is not ready or available for
sending a fax
During polling faxing,
original documents were
not set on the other end
machine
Confirm the condition of
the other end machine,
and ask the sender to
resend the fax.
*4 External error code 50H: Forced stop Transmitting a fax is finished
300 046 0x302E
The other end machine is not ready or available for
receiving a fax
The other end machine
runs out of paper or the
memory is full
Confirm the condition of
the other end machine,
and resend the fax.
*4 External error code 50H: Forced stop Transmitting a fax is finished
300 047 0x302F
The product disconnect the line because it received
forced polled transmission (for maintenance) in the
middle of processing a fax job
Not used --- --- --- --- ---
300 048 0x3030
DCN reception During the fax
communication,
something went wrong
with the other end
machine
If the error occurs when
transmitting, resend the
fax. If the error occurs
during receiving process,
ask the sender to resend
the fax
*4 External error code 50H: Forced stop Transmitting a fax is finished
Receiving a fax is finished
300 049 0x3031
Auto dialing function is used, but no data is stored for
the function.
The speed-dial memory is
deleted
Check if the number of
the speed-dial memory is
correct, and try the
operation again.
*5 External error code 50H: Forced stop Transmitting a fax is finished
Table 7-23. Operator Call Error
External
error code
Internal
Code
Description Cause Remedies
Panel
Display
(reference)
Report Display
Trigger for
Stopping
Operation
Notification Message
MAIN SUB

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English