Command Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Information Center Configuration
Commands
Huawei Technologies Proprietary
1-7
Use the undo info-center channel command to restore the default name of the
channel of the specified number.
By default, the name of channel 0 to channel 9 is (in turn) console, monitor, loghost,
trapbuffer, logbuffer, snmpagent, channel6, channel7, channel8, channel9.
Note that, you cannot configure two different channel numbers with the same name.
Example
# Name channel 0 as “execconsole”.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center channel 0 name execconsole
1.1.7 info-center console channel
Syntax
info-center console channel { channel-number | channel-name }
undo info-center console channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10
channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in
turn) console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6,
channel7, channel8, channel9.
Description
Use the info-center console channel command to set the channel through which
information is output to the console.
By default, the switch outputs information to the console.
This command works only when the information center is enabled for the system.
Related command: info-center enable and display info-center.
Example
# Configure channel 0 to output information to the console.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center console channel 0
To Next Page
Loading...
Need help?
General