Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-15
2.1.16 rip input
Syntax
rip input
undo rip input
View
Interface view
Parameter
None
Description
Use the rip input command to enable an interface to receive RIP packets.
Use the undo rip input command to disable an interface from receiving RIP packets.
By default, all interfaces, except loopback interfaces, can receive RIP packets.
This command is used in cooperation with another two commands: rip output and rip
work. Functionally, rip work is equivalent to rip input & rip output. The latter two
control the receipt and the transmission of RIP packets respectively on an interface.
The former command equals the functional combination of the latter two commands.
Related command: rip output, rip work.
Example
# Configure the interface Vlan-interface 10 not to receive RIP packets.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway]interface Vlan-interface 10
[Quidway-Vlan-interface10] undo rip input
2.1.17 rip metricin
Syntax
rip metricin value
undo rip metricin
View
Interface view

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English