Huawei Quidway S3900 Series - Logging-Host; Management-Vlan

Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-34
Example
# Configure the IP address range of a cluster.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] cluster
[Quidway-cluster] ip-pool 10.200.0.1 20
1.3.18 logging-host
Syntax
logging-host ip-address
undo logging-host
View
Cluster view
Parameter
ip-address: IP address of the logging host configured for the cluster.
Description
Use the logging-host command to configure a logging host on the management
device for the member devices in the cluster.
Use the undo logging-host command to cancel the logging host configuration.
By default, no logging host is configured.
Note that you need to configure the IP address of a logging host first for the member
devices in a cluster to send log information to the logging host through the
management device.
Example
# Configure the IP address of the logging host on the management device.
<aaa_0.Quidway> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Quidway] cluster
[aaa_0.Quidway-cluster] logging-host 10.10.10.9
1.3.19 management-vlan
Syntax
management-vlan vlan-id