Command Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-9
interface-type interface-number ] } &<1-10>, where &<1-10> means that you can
provide up to 10 port indexes/port index ranges for this argument.
Description
Use the reset stp command to clear spanning tree-related statistics on Ethernet ports.
The spanning tree statistics include the numbers of the TCN BPDUs, configuration
BPDUs, RST BPDUs, and MST BPDUs sent/received through one or more specified
ports or all ports (note that STP BPDUs and TCN BPDUs are counted only for CISTs.)
This command clears the spanning tree-related statistics on specified ports if you
specify the interface-list argument. If you do not specify the interface-list argument, this
command clears the spanning tree-related statistics on all ports.
Related command: display stp.
Example
# Clear the spanning tree-related statistics on ports Ethernet1/0/1 through
Ethernet1/0/3.
<Quidway> reset stp interface Ethernet 1/0/1 to Ethernet 1/0/3
1.1.9 revision-level
Syntax
revision-level level
undo revision-level
View
MST region view
Parameter
level: MSTP revision level to be set for the switch. This argument ranges from 0 to
65,535. By default, the MSTP revision level of a switch is 0.
Description
Use the revision-level command to set the MSTP revision level for a switch.
Use the undo revision-level command to revert to the default revision level.
MSTP revision level, along with MST region name and VLAN mapping table,
determines the MST region which a switch belongs to.
Related command: instance, region-name, check region-configuration,
vlan-mapping modulo, and active region-configuration.
To Next Page
Loading...
Need help?
General