Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-45
Example
# Set the peer dead interval on the interface Vlan-interface 10 to 80 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf timer dead 80
3.1.41 ospf timer hello
Syntax
ospf timer hello seconds
undo ospf timer hello
View
Interface view
Parameter
seconds: Interval, in seconds, at which an interface transmits hello packet. It ranges
from 1 to 255.
Description
Use the ospf timer hello command to configure the interval for transmitting Hello
messages on an interface.
Use the undo ospf timer hello command to restore the interval to the default value.
By default, the interval is 10 seconds for an interface of p2p or broadcast type to
transmit Hello messages, and 30 seconds for an interface of p2mp or nbma type.
Related command: ospf timer dead.
Example
# Configure the interval of transmitting Hello messages on the interface Vlan-interface
10 to 20 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf timer hello 20
3.1.42 ospf timer poll
Syntax
ospf timer poll seconds

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English