Huawei Quidway S3900 Series Command Manual

Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Management VLAN Configuration
Commands
Huawei Technologies Proprietary
1-12
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0 Tag: 0
Refer to Table 1-5 for the description on the output fields.
1.1.8 display ip routing-table ip-address1 ip-address2
Syntax
display ip routing-table ip-address1 mask1 ip-address2 mask2 [ verbose ]
View
Any view
Parameter
ip-address1, ip-address2: Destination IP addresses in dotted decimal notation.
ip-address1 and mask1, together with ip-address2 and mask2, determine an IP
address range. The starting address of the IP address range is obtained by performing
AND operation between the ip-address1 and mask1 arguments; and the end address
of the IP address range is obtained by performing AND operation between the
ip-address2 and mask2 arguments.
mask1, mask2: IP address masks. These two arguments can be in dotted decimal
notation or two integers ranging from 0 to 32.
verbose: Displays the detailed information about the active and inactive routes. If you
do not specify this keyword, only the summary information about the active routes is
displayed.
Description
Use the display ip routing-table ip-address1 ip-address2 command to display the
information about the routes with their destinations within the specified destination IP
address range.
Example
# Display the information about the routes with their destinations within the range of
1.1.1.0 to 2.2.2.0.
<Quidway> display ip routing-table 1.1.1.0 24 2.2.2.0 24
Routing tables:
Summary count: 3
Destination/Mask Protocol Pre Cost Nexthop Interface
1.1.1.0/24 DIRECT 0 0 1.1.1.1 Vlan-interface1
Refer to Table 1-4 for the description on the output fields.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English