Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Management VLAN Configuration
Commands
Huawei Technologies Proprietary
1-13
1.1.9 display ip routing-table ip-prefix
Syntax
display ip routing-table ip-prefix ip-prefix-name [ verbose ]
View
Any view
Parameter
ip-prefix-name: Name of an IP prefix list, a string comprising 1 to 19 characters.
verbose: Displays the detailed information about the active and inactive routes
matching a specified IP prefix list. If you do not specify this keyword, only the summary
information about the active routes matching the IP prefix list is displayed.
Description
Use the display ip routing-table ip-prefix command to display the information about
the routes matching a specified IP prefix list.
You can use this command to trace routing policies and display the routes matching a
specified IP prefix list.
If the specified IP prefix list does not exist, the detailed information about all the active
and inactive routes is displayed when you execute this command with the verbose
keyword specified, and only the summary information about all the active routes is
displayed if you execute this command with the verbose keyword not specified.
Example
# Display the summary information about the active routes matching the IP prefix list
named abc2.
[Quidway] display ip routing-table ip-prefix abc2
Routes matched by ip-prefix abc2:
Summary count: 2
Destination/Mask Protocol Pre Cost Nexthop Interface
10.1.1.0/24 DIRECT 0 0 10.1.1.2 Vlan-interface1
10.1.1.2/32 DIRECT 0 0 127.0.0.1 InLoopBack0
Refer to Table 1-4 for the description on the output fields.
# Display the detailed information about the active and inactive routes matching the IP
prefix list named abc2.
<Quidway> display ip routing-table ip-prefix abc2 verbose
Routes matched by ip-prefix abc2:
+ = Active Route, - = Last Active, # = Both * = Next hop in use
To Next Page
Loading...
Need help?
General