Huawei Quidway S3900 Series - Chapter 3 OSPF Configuration Commands; OSPF Configuration Commands; Abr-Summary

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-1
Chapter 3 OSPF Configuration Commands
 Note:
Among S3900 Series Ethernet Switches, only S3900-EI series support OSPF protocol.
 Note:
When running a routing protocol, the Ethernet switch also functions as a router. The
words “router” and the router icons covered in the following text represent routers in
common sense and Ethernet switches running a routing protocol. To improve
readability, this will not be mentioned again in this manual.
3.1 OSPF Configuration Commands
3.1.1 abr-summary
Syntax
abr-summary ip-address mask [ advertise | not-advertise ]
undo abr-summary ip-address mask
View
OSPF Area view
Parameter
ip-address: Network segment address.
mask: Network mask.
advertise: Specifies to advertise the aggregated route that match a specific IP address
and mask.
not-advertise: Specifies not to advertise the aggregated route that match a specific IP
address and mask.
Description
Use the abr-summary command to enable route aggregation on an area border router
(ABR).