Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-11
3.1.12 display debugging ospf
Syntax
display debugging ospf
View
Any view
Description
Use the display debugging ospf command to display the debugging states of OSPF
processes.
Example
# Display the debugging states of OSPF processes.
<Quidway> display debugging ospf
OSPF process 1 debugging state:
OSPF EVENT debugging switch is on
3.1.13 display ospf abr-asbr
Syntax
display ospf [ process-id ] abr-asbr
View
Any view
Parameter
process-id: OSPF Process ID. If you do not specify a process ID, this command applies
to all current OSPF processes .
Description
Use the display ospf abr-asbr command to display the information about the ABR and
ASBR of OSPF.
Example
# Display the information about the OSPF ABRs and ASBRs.
<Quidway> display ospf abr-asbr
OSPF Process 1 with Router ID 1.1.1.1
Routing Table to ABR and ASBR
I = Intra i = Inter A = ASBR B = ABR S = SumASBR
Destination Area Cost Nexthop Interface