New Feature Manual - DHCP
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 DHCP Server Configuration
Commands
Huawei Technologies Proprietary
1-3
z After you enable DHCP by using the dhcp enable command, if the DHCP server
and DHCP relay are not configured, sockets UDP 67 and UDP 68 will not be
enabled. If the DHCP server and DHCP relay are configured, sockets UDP 67 and
UDP 68 will be enabled.
z After you disable DHCP by using the undo dhcp enable command, even if the
DHCP server and DHCP relay are configured, sockets UDP 67 and UDP 68 will be
disabled.
Example
# Enter system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
# Enable DHCP.
[Quidway] dhcp enable
1.1.3 dhcp select global
Syntax
VLAN interface view:
dhcp select global
undo dhcp select
System view:
dhcp select global { interface interface-type interface-number [ to interface-type
interface-number ] | all }
undo dhcp select { interface interface-type interface-number [ to interface-type
interface-number ] | all }
View
System view and VLAN interface view
Parameter
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies the interface(s) to operate in global address pool mode. The interface-type
and interface-number arguments are the type and number of an interface. The to
keyword separates the start and the end of an interface range.
all: Specifies all ports to operate in global address pool mode.
To Next Page
Loading...
Need help?
General