Command Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Information Center Configuration
Commands
Huawei Technologies Proprietary
1-9
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10
channels of the system.
channel-name: Channel name, by default, the name of channel 0 to channel 9 is (in
turn) console, monitor, loghost, trapbuffer, logbuffer, snmpagent, channel6,
channel7, channel8, channel9.
size buffersize: Specifies the size of the log buffer (number of messages the buffer
holds) you want to display. The buffersize argument ranges from 0 to 1024 and defaults
to 512.
Description
Use the info-center logbuffer command to enable information output to the log buffer..
Use the undo info-center logbuffer command to disable the information output.
By default, the switch outputs information to the log buffer, which can hold 512 records
by default.
This command works only when the information center is enabled for the system.
Related command: info-center enable and display info-center.
Example
# Configure the switch to output information to the log buffer with the size of 50.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center logbuffer size 50
1.1.10 info-center loghost
Syntax
info-center loghost host-ip-addr [ channel { channel-number | channel-name } |
facility local-number | language { chinese | english } ]*
undo info-center loghost host-ip-addr
View
System view
Parameter
host-ip-addr: IP address of a log host.
channel: Sets the information channel for the log host.
channel-number: Channel number, ranging from 0 to 9, corresponding to the 10
channels of the system.
To Next Page
Loading...
Need help?
General