Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-20
Note:
To protect the unused sockets against malicious attacks and improve the switch
security, S3900 series Ethernet switches provide the following function:
z When the cluster function is enabled, socket UDP 40000 used by the cluster is
enabled;
z When the cluster function is disabled, socket UDP 40000 is disabled at the same
time.
This function is implemented on the command switch in the following scenarios:
z Use the build command or the auto-build command to create a cluster and enable
socket UDP 40000 used by the cluster at the same time.
z Use the undo build command or the undo cluster enable command to remove a
cluster and disable socket UDP 40000 at the same time.
This function is implemented on the member switch in the following scenarios:
z Use the add-member command on the management device to add a candidate
switch into the cluster and enable socket UDP 40000 of the new member.
z Use the auto-build command on the management device to add a candidate switch
into the cluster and enable socket UDP 40000 of the new member.
z Use the administrator-address command on the current switch to enable socket
UDP 40000.
z Use the delete-member command on the management device to delete a cluster
member and disable socket UDP 40000 of the member switch.
z Use the undo build command on the management device to delete a cluster and
disable sockets UDP 40000 of all the cluster members.
z Use the undo administrator-address command on a member switch to disable
socket UDP 40000 of the member switch.
1.3.5 cluster
Syntax
cluster
View
System view
Parameter
None
Description
Use the cluster command to enter cluster view.
To Next Page
Loading...
