Command Manual – VRRP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 VRRP Configuration Commands
 Note:
The S3900-EI series switches support the VRRP feature, but not the S3900-SI series.
1.1 VRRP Configuration Commands
1.1.1 display vrrp
Syntax
display vrrp [ interface Vlan-interface valn-id | statistics [ Vlan-interface vlan-id ] ]
[ virtual-router-id ]
View
Any view
Parameter
interface: Displays VRRP information about the specified VLAN interface.
vlan-id: VLAN interface ID.
statistics: Displays VRRP statistics.
virtual-router-id: VRRP backup group ID ranging from 1 to 255.
Description
Use the display vrrp command to display the information about the VRRP state or
VRRP statistics.
When VRRP status information is displayed:
z If the interface index and backup group ID are not specified, the state information
about all the backup groups on the switch is displayed.
z If only the interface index is specified, the state information about all the backup
groups on the interface is displayed.
z If both the interface index and backup group ID are specified, the state information
about the specified backup group on the interface is displayed.
When VRRP statistics information is displayed: