Huawei Quidway S3900 Series Command Manual

Command Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 SNMP Configuration Commands
Huawei Technologies Proprietary
1-11
Use the undo snmp-agent community command to cancel the settings of community
access name.
Example
# Configure community name as comaccess and permit read-only access by this
community name.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] snmp-agent community read comaccess
# Configure community name as mgr and permit read-write access.
[Quidway] snmp-agent community write mgr
# Remove community name comaccess.
[Quidway] undo snmp-agent community comaccess
1.1.12 snmp-agent group
Syntax
1) Versions V1 and V2C
snmp-agent group { v1 | v2c } group-name [ read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group { v1 | v2c } group-name
2) Version V3
snmp-agent group v3 group-name [ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group v3 group-name [ authentication | privacy ]
View
System view
Parameter
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
groupname: Group name, ranging from 1 to 32 bytes.
authentication: Configures to authenticate the packet without encryption.
privacy: Configures to authenticate and encrypt the packet.
readview: Read-only view name, ranging from 1 to 32 bytes.
writeview: Name of read-write view, ranging from 1 to 32 bytes.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English