Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-11
undo peer ip-address
View
RIP view
Parameter
ip-address: IP address of the interface on the peer router with which routing information
needs to be exchanged, in dotted decimal notation.
Description
Use the peer command to configure the destination address of the peer device with
which routing information should be exchanged in unicast mode.
Use the undo peer command to cancel a unicast address.
By default, RIP does not send packets to any address in unicast mode.
This command is used to for non-broadcast networks to which protocol packets cannot
be sent in broadcast mode. And you are not recommended to use this command in
normal situation.
Example
# Specify a unicast destination address of 202.38.165.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] rip
[Quidway-rip] peer 202.38.165.1
2.1.12 preference
Syntax
preference value
undo preference
View
RIP view
Parameter
value: Preference level, ranging from 1 to 255. By default, the value is 100.
Description
Use the preference command to configure the route preference of RIP.
Use the undo preference command to restore the default preference.
To Next Page
Loading...
Need help?
General