Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-32
View
Cluster view
Parameter
ip-address: IP address of the FTP server to be configured for the cluster.
Description
Use the ftp-server command to configure an FTP server on the management device
for the member devices in the cluster.
Use the undo ftp-server command to remove the FTP server configured for the
member devices in the cluster.
By default, the management device acts as the FTP Server.
You need to configure the IP address of an FTP server first for the member devices in a
cluster to access the FTP server through the management device.
Example
# Configure the IP address of an FTP server on the management device.
<aaa_0.Quidway> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Quidway] cluster
[aaa_0.Quidway-cluster] ftp-server 1.0.0.9
1.3.16 holdtime
Syntax
holdtime seconds
undo holdtime
View
Cluster view
Parameter
seconds: Holdtime (in seconds) ranging from 1 to 255.
Description
Use the holdtime command to configure the holdtime of a switch.
Use the undo holdtime command to restore the default holdtime value.
z If a switch does not receive any information of a peer device during the holdtime, it
sets the state of the peer device to “down”. When the communication between the
To Next Page
Loading...
Need help?
General