Huawei Quidway S3900 Series - Display Ospf Vlink

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-31
Field Description
ASE Number of external routes
NSSA Number of NSSA routes
3.1.25 display ospf vlink
Syntax
display ospf [ process-id ] vlink
View
Any view
Parameter
process-id: OSPF Process ID. If you do not specify a process ID, this command applies
to all current OSPF processes.
Description
Use the display ospf vlink command to display the information about OSPF virtual
links.
Example
# Display OSPF virtual link information.
<Quidway> display ospf vlink
OSPF Process 1 with Router ID 1.1.1.1
Virtual Links
Virtual-link Neighbor-id -> 2.2.2.2, State: Full
Cost: 0 State: Full Type: Virtual
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 3-16 Description on the fields of the display ospf vlink command
Field Description
Virtual-link
Neighbor-id
Router ID of virtual-link neighbor router
State State
Interface IP address of the interface on the virtual link
Cost Route cost of the interface
Type Type: virtual link