Huawei Quidway S3900 Series Command Manual

Command Manual – Mirroring
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Mirroring Commands
Huawei Technologies Proprietary
1-7
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 monitor-port Gigabitethernet1/1/4
1.1.7 mirroring-group reflector-port
Syntax
mirroring-group group-id reflector-port reflector-port
undo mirroring-group group-id reflector-port reflector-port
View
System view/Ethernet port view
Parameter
group-id: Group number of a port mirroring group, in the range of 1 to 20.
reflector-port reflector-port: Specifies the reflector port. reflector-port is available in
system view only, but not in Ethernet port view.
Description
Use the mirroring-group reflector-port command to specify the reflector port.
Use the undo mirroring-group reflector-port command to remove the configuration
of the reflector port..
Note the following when you configure the reflector port:
z The reflector port must be an Access port.
z LACP and TCP must be disabled on the reflector port.
z After a port is configured as a reflector port, the switch does not allow you to
change the port type and its default VLAN ID, or to add it to another VLAN.
z To mirror tagged packets, you need to configure VLAN VPN on the reflector port.
Example
# Configure GigabitEthernet1/1/2 as the reflector port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 reflector-port GigabitEthernet1/1/2
1.1.8 mirroring-group remote-probe vlan
Syntax
mirroring-group group-id remote-probe vlan remote-probe-vlan-id

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English