Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 4 IP Routing Policy Configuration
Commands
Huawei Technologies Proprietary
4-4
Description
Use the display route-policy command to display the configured Route-policy.
If you do not specify a route policy name, this command displays all route-policies
configured.
Related command: route-policy.
Example
# Display the information about Route-policy named policy1.
<Quidway> display route-policy policy1
Route-policy : policy1
Permit 10 : if-match (ip-prefix) p1
apply cost 100
matched : 0 denied : 0
Table 4-2 Description on the fields of the display route-policy command
Field Description
Route-policy Name of ip-prefix
Information about the route-policy with the mode configured as
permit and the node as 10:
if-match
(prefixlist) p1
if-match clause configured
apply cost 100
Apply routing cost 100 to the routes matching
the conditions defined by if-match clause
matched
Number of routes matching the conditions set
by if-match clause
Permit 10
denied
Number of routes not matching the conditions
set by if-match clause
4.1.5 if-match acl
Syntax
if-match { acl acl-number | ip-prefix ip-prefix-name }
undo if-match { acl | ip-prefix }
View
Route policy view
Parameter
acl-number: Number of the ACL used for filter
To Next Page
Loading...
