Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-54
3.1.52 stub
Syntax
stub [ no-summary ]
undo stub
View
OSPF Area view
Parameter
no-summary: Disables an ABR from transmitting Summary LSAs to the STUB area.
Description
Use the stub command to configure the type of an OSPF area as "stub".
Use the undo stub command to cancel the settings.
By default, no area is set to be the STUB area.
If the router is an ABR, it will send a default route to the connected stub area . Use the
default-cost command to configure the default route cost. In addition, you can specify
the no-summary argument in the stub command to disable the receiving of type-3
LSAs by the stub area connected to the ABR.
Related command: default-cost.
Example
# Set the type of OSPF area 1 to STUB.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ospf 1
[Quidway-ospf-1] area 1
[Quidway-ospf-1-area-0.0.0.1] stub
3.1.53 vlink-peer
Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds |
dead seconds | simple password | md5 keyid key ]*
undo vlink-peer router-id
View
OSPF Area view

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English