Huawei Quidway S3900 Series - Display Packet-Filter; Display Time-Range

Command Manual – ACL
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 ACL Commands
Huawei Technologies Proprietary
1-4
rule 1 permit ip
1.1.4 display packet-filter
Syntax
display packet-filter { interface interface-type interface-num | unitid unit-id }
View
Any view
Parameter
interface-type interface-num: Port of the switch.
unit-id: Unit ID, used to specify to display the information of a specific unit.
Description
Use the display packet-filter command to view the application information of packet
filtering, including the ACL name, rule names, and application status.
Example
# Display the application information of packet filtering on Unit 1.
<Quidway> display packet-filter unitid 1
1.1.5 display time-range
Syntax
display time-range { all | name }
View
Any view
Parameter
all: Specifies to display all time ranges.
name: Name of a time range, a string that starts with [a-z, A-Z] and contains up to 32
characters.
Description
Use the display time-range command to view the configuration and status of the
current time range. For an active time range, this command displays “active”; for an
inactive time range, this command displays “inactive”.
Related command: time-range.