New Feature Manual - DHCP
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 DHCP Server Configuration
Commands
Huawei Technologies Proprietary
1-36
Example
# Enter system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
# Configure the DHCP clients of the global DHCP address pool 0 to be of b-node type.
[Quidway] dhcp server ip-pool 0
[Quidway-dhcp-pool-0] netbios-type b-node
1.1.32 network
Syntax
network ip-address [ mask mask ]
undo network
View
DHCP address pool view
Parameter
ip-address: IP address of a network segment., used to specify an IP address range.
mask mask: Specifies a subnet mask in dotted decimal notation.
If neither subnet mask nor mask length is specified in this command, the default
subnet mask is adopted.
Description
Use the network command to configure a dynamically assigned IP address range
(where IP addresses will be dynamically assigned to DHCP clients).
Use the undo network command to remove a dynamically assigned IP address
range.
By default, no such IP address range is configured for a DHCP address pool.
Note that you can configure only one such IP address range for a DHCP address pool.
If you execute the network command repeatedly, the new configuration overwrites the
previous one.
Related command: dhcp server ip-pool and dhcp server forbidden-ip.
Example
# Enter system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
Need help?
General