Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-51
ID, the router will automatically select one from configured IP addresses as the ID of
this router. If no IP address is configured for any interface of the router, the router ID
must be configured in OSPF view. Otherwise, OSPF protocol cannot be enabled.
When the router ID is configured manually, the IDs of any two routers cannot be same
in the autonomous system. Thus, you can select the IP address of an interface as the
ID of this router.
 Note:
A modified router ID takes effect only after OSPF is re-enabled.
Related command: ospf.
Example
# Set the router ID to 10.1.1.3.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] router id 10.1.1.3
3.1.49 silent-interface
Syntax
silent-interface silent-interface-type silent-interface-number
undo silent-interface silent-interface-type silent-interface-number
View
OSPF view
Parameter
silent-interface-type: Interface type
silent-interface-number: Interface number.
Description
Use the silent-interface command to disable an interface from transmitting OSPF
packet.
Use the undo silent-interface command to restore the default setting.
By default, the interface is enabled to transmit OSPF packet.
To prevent the router on some network from receiving the OSPF routing information,
you can use this command to disable this interface from transmitting OSPF packet. On

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English