Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-13
Parameter
interval-in- minutes: Interval (in minutes) to collect topology information, ranging from 0
to 65,535. This argument defaults to 0, which specifies not to collect topology
information.
Description
Use the ntdp timer command to configure the interval to collect topology information.
Use the undo ntdp timer command to restore the default interval.
B y default, the interval to collect topology information is 1 minute.
A switch collects topology information once in each period set by the ntdp timer
command.
Note that:
z The (disable) prompt in the timer field of the display ntdp command means that
the device is not the member of the cluster and does not perform periodical
topology collection.
z After the cluster is set up, the S3900 switch will collect the topology information in
the network at the set interval and add the detected candidate switches into the
cluster automatically.
z If it is unnecessary to add the candidate switches into the cluster automatically,
you can set the interval of topology collection to 0.
Example
# Set the interval to collect topology information to 30 minutes.
<aaa_0.Quidway> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Quidway] ntdp timer 30
1.2.7 ntdp timer hop-delay
Syntax
ntdp timer hop-delay time
undo ntdp timer hop-delay
View
System view
Parameter
time: Delay time (in milliseconds) for a switch to forward topology-collection request
packets. This argument ranges from 1 to 1,000 and defaults to 200.
To Next Page
Loading...
