Huawei Quidway S3900 Series Command Manual

Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Login Commands
Huawei Technologies Proprietary
1-17
Description
Use the send command to send messages to a specified user interface or all user
interfaces.
Example
# Send “hello” to all user interfaces.
<Quidway> send all
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello^Z
Send message? [Y/N]y
1.1.18 service-type
Syntax
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] }
undo service-type { ftp | lan-access | { ssh | telnet | terminal }* }
View
Local user view
Parameter
ftp: Specifies the users to be of FTP type.
lan-access: Specifies the users to be of LAN-access type, which normally means
Ethernet users, such as 802.1x users.
ssh: Specifies the users to be of SSH type.
telnet: Specifies the users to be of Telnet type.
terminal: Makes terminal services available to users logging in through the Console
port.
level level: Specifies the user level for Telnet users, Terminal users, or SSH users. The
level argument ranges from 0 to 3 and defaults to 0.
Description
Use the service-type command to specify the login type and the corresponding
available command level.
Use the undo service-type command to cancel login type configuration.
Commands fall into four command levels: access, monitor, system, and administration,
which are described as follows:
z Access level: Commands of this level are used to diagnose network and change
the language mode of user interface, such as the ping, tracert, and

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English