Huawei Quidway S3900 Series Command Manual

Command Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 SNMP Configuration Commands
Huawei Technologies Proprietary
1-21
You can configure this command to trace a specific event using the source address of a
Trap packet.
 Note:
Before setting the IP address of an interface address as the source address of the sent
Trap packet, you must configure an IP address for the interface.
Related command: snmp-agent trap enable, snmp-agent target-host.
Example
# Configure the IP address of the VLAN interface 1 as the source address for
transmitting the Trap packets.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] snmp-agent trap source Vlan-interface 1
1.1.23 snmp-agent usm-user
Syntax
1) Versions V1 and V2C
snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number ]
undo snmp-agent usm-user { v1 | v2c } user-name group-name
2) Version V3
snmp-agent usm-user v3 user-name group-name [ authentication-mode { md5 |
sha } auth-password [ privacy-mode des56 priv-password ] ] [ acl acl-number ]
undo snmp-agent usm-user v3 user-name group-name { local | engineid
engineid-string }
View
System view
Parameter
v1: Configures to use V1 security model.
v2c: Configures to use V2c security model.
v3: Configures to use V3 security model.
User-name: User name, ranging from 1 to 32 bytes.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English