Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-25
1.3.11 display cluster
Syntax
display cluster
View
Any view
Parameter
None
Description
Use the display cluster command to display the state and statistics of the cluster to
which the current switch belongs.
When being executed on a member device, this command displays the information
such as cluster name, member number of the current switch, the MAC address and
state of the management device, holdtime, and the interval to send packets.
When being executed on a management device, this command displays the
information such as cluster name, the number of the member devices in the cluster,
cluster state, holdtime and the interval to send packets.
Errors occur if you execute this command on a switch that does not belong to any
cluster.
Example
# Display cluster information (assuming that the current switch is a management
device).
<aaa_0.Quidway-cluster> display cluster
Cluster name:"aaa"
Role:Administrator
Management-vlan:100
Handshake timer:10 sec
Handshake hold-time:60 sec
IP-Pool:20.1.1.1/24
cluster-mac:0180-c200-000a
No logging host configured
No SNMP host configured
No FTP server configured
No TFTP server configured
To Next Page
Loading...
Need help?
General