Command Manual – Auto Detect
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 Auto Detect Configuration Commands
Huawei Technologies Proprietary
1-2
Parameter
list-number: Sequence number of the IP address to be added to the detecting group.
This argument ranges from 1 to 10.
ip address ip-address: Specifies the IP address (in dotted decimal notation) to be
detected.
nexthop ip-address: Specifies the next hop IP address.
Description
Use the detect-list command to add an IP address to a detecting group. This
command also specifies the order in which the IP addresses in a detecting group are
detected.
Use the undo detect-list command to specify to skip a specified IP address when
performing auto detect operations.
When performing auto detect operations, a switch detects the IP addresses by their
list-number values in an ascending order. Up to 100 IP addresses can be configured
in a detecting group. You can specify how the detecting result is generated using the
option command.
Related command: option.
Example
# Add the IP address of 202.13.1.55 to detecting group 10, with list-number set to 1,
the next hop IP address set to 1.2.3.4.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] detect-group 10
[Quidway-detect-group-10] detect-list 1 ip address 202.13.1.55 nexthop
1.2.3.4
1.1.3 display detect-group
Syntax
display detect-group [ group-number ]
View
Any view
Parameter
group-number: Detecting group number ranging from 1 to 25.
To Next Page
Loading...
Need help?
General