Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 7 MSDP Configuration Commands
Huawei Technologies Proprietary
7-12
View
MSDP view
Parameter
peer-address: IP address of the MSDP peer to which the TTL threshold applies.
ttl-value: TTL threshold, ranging from 0 to 255.
Description
Use the peer minimum-ttl command to configure the minimum TTL value of the
multicast data packets encapsulated in SA messages and to be sent to the specified
MSDP peer.
Use the undo peerminimum-ttl command to restore the default TTL threshold.
By default, the value of TTL threshold is 0.
Related command: peer.
Example
# Set the TTL threshold to 10, so that only those multicast data packets with a TTL
value greater than or equal to 10 can be forwarded to the MSDP peer 110.10.10.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] msdp
[Quidway-msdp] peer 110.10.10.1 minimum-ttl 10
7.1.13 peer request-sa-enable
Syntax
peer peer-address request-sa-enable
undo peer peer-address request-sa-enable
View
MSDP view
Parameter
peer-address: IP address of the MSDP peer.
Description
Use the peer request-sa-enable command to enable the router to send an SA request
message to the specified MSDP peer upon receipt of a Join message.
Use the undo peer request-sa-enable command to remove the configuration.
To Next Page
Loading...
Need help?
General