Command Manual – MAC Address Table
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 MAC Address Table Configuration
Commands
Huawei Technologies Proprietary
1-5
Value Description
{ static | dynamic | blackhole }
mac-address [ interface interface-type
interface-number ] vlan vlan-id
Removes a specified static, dynamic, or
blackhole MAC address entry.
interface interface-type
interface-number
Removes all the MAC address entries
concerning a specified port.
vlan vlan-id
Removes all the MAC address entries
concerning a specified VLAN.
mac-address [ interface interface-type
interface-number ] vlan vlan-id
Removes a specified MAC address
entry.
Description
Use the mac-address command to add/modify a MAC address entry.
Use the undo mac-address command to remove one or more MAC address entries.
When being executed in port view, these two commands only apply to the current port.
In this case, the interface keyword is unnecessary.
If the MAC address you input in the mac-address command already exists in the MAC
address table, the system will modify the attributes of the corresponding MAC address
entry according to your settings in the command.
You can remove all MAC address entries (unicast MAC addresses only) concerning a
specific port, or remove a specific type of MAC address entries, such as the addresses
learnt by the system, dynamic or static MAC address entries configured, or blackhole
addresses.
Example
# Configure a static MAC address entry with the following settings:
z MAC address: 00e0-fc01-0101
z Outbound port: Ethernet1/0/1 port
z Ethernet1/0/1 port belongs to VLAN 2.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mac-address static 00e0-fc01-0101 interface Ethernet 1/0/1 vlan 2
1.1.4 mac-address max-mac-count
Syntax
mac-address max-mac-count count
undo mac-address max-mac-count
To Next Page
Loading...
