Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-16
After a candidate device is added to a cluster, its device password becomes the
management device password.
Note that:
After the cluster is set up, the S3900 switch will collect the topology information of the
network at the set interval and add the detected candidate devices into the cluster
automatically. If it is unnecessary to add the candidate switches into the cluster
automatically, you can set the interval of topology collection to 0, that is, topology
collection is not performed periodically.
Example
# Add a candidate device to the cluster, setting the member number to 6. (Assume that
the MAC address and user password of the candidate device are 00E0-fc00-35e7 and
123456.)
<aaa_0.Quidway> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Quidway] cluster
[aaa_0.Quidway-cluster] add-member 6 mac-address 00E0-fc00-35e7 password
123456
1.3.2 administrator-address
Syntax
administrator-address mac-address name name
undo administrator-address
View
Cluster view
Parameter
mac-address: MAC address of the management device.
name name: Name of an existing cluster, a string comprising up to 8 characters, which
can only be alphanumeric characters, subtraction sign (-), and underline (_).
Description
Use the administrator-address command to set the MAC address of the management
device on a member device.
Use the undo administrator-address command to remove a member device from the
cluster, usually for debugging or restoration.
By default, a switch belongs to no cluster.
To Next Page
Loading...
Need help?
General