Command Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 802.1x Configuration Commands
Huawei Technologies Proprietary
1-1
Chapter 1 802.1x Configuration Commands
1.1 802.1x Configuration Commands
1.1.1 display dot1x
Syntax
display dot1x [ sessions | statistics ] [ interface interface-list ]
View
Any view
Parameter
sessions: Displays the formation about 802.1x sessions.
statistics: Displays the statistics information about 802.1x.
interface: Display the 802.1x-related information about a specified port.
interface-list: Ethernet port list. You can specify multiple Ethernet ports by providing
this argument in the form of interface-list = { interface-name [ to interface- name] & <
1-10 >. The interface-name argument is the port index of an Ethernet port and can be
specified in this form: interface-name = { interface-type interface-num }, in which,
interface-type specifies the type of an Ethernet port and interface-num identifies the
number of the port. Note that the interface name after the keyword to must have an
interface-num that is greater than or equal to that of the interface-name before to.
“&<1-10>” means that up to 10 port indexes/port index lists can be provided.
Description
Use the display dot1x command to display 802.1x-related information, such as
configuration information, operation information (session information), and statistics.
When the interface-list argument is not provided, this command displays
802.1x-related information on all ports. The output information can be used to verify
802.1 x-related configurations and to troubleshoot.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user,
dot1x port-control, dot1x port-method, and dot1x timer.
Example
# Display 802.1x-related configuration information.
<Quidway> display dot1x
Equipment 802.1X protocol is enabled
To Next Page
Loading...
Need help?
General