Huawei Quidway S3900 Series Command Manual

Command Manual – Link Aggregation
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Link Aggregation Configuration
Commands
Huawei Technologies Proprietary
1-1
Chapter 1 Link Aggregation Configuration
Commands
1.1 Link Aggregation Configuration Commands
1.1.1 display link-aggregation interface
Syntax
display link-aggregation interface interface-type interface-number [ to
interface-type interface-number ]
View
Any view
Parameter
interface-type: Port type.
interface-number: Port number.
to: Specifies a group of contiguous ports..
Description
Use the display link-aggregation interface command to display the link aggregation
details about a specified port or port range, including:
z Link aggregation group ID, port priority, operation key and protocol status flag of
the port at the local end,
z Device ID, port number, port priority, operation key and protocol status flag at the
remote end, and,
z LACP protocol packet statistics.
Note that, for a manual aggregation group, value 0 is displayed for all the above items
of the remote end (which does not indicate the real information of the remote end),
since information about the remote end cannot be obtained for a manual aggregation
group.
Example
# Display the link aggregation details on Ethernet1/0/1.
<Quidway> display link-aggregation interface Ethernet1/0/1
Ethernet1/0/1:
Selected AggID: 1
Local:

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English