Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-35
undo management-vlan
View
System view
Parameter
vlan-id: ID of the VLAN to be specified as the management VLAN.
Description
Use the management-vlan command to specify the management VLAN on the switch.
Use the undo management-vlan command to restore the default management VLAN.
By default, VLAN 1 is the management VLAN.
Note the following when configuring the management VLAN:
z The management VLANs specified on different devices in the same cluster must
be the same VLAN.
z The management VLAN can only be specified before the cluster is created. Once
a switch is added to a cluster, the management VLAN configuration cannot be
modified. To modify management VLAN configuration on a switch belonging to a
cluster, you need to cancel the cluster-related configurations on the switch,
specify the desired VLAN to be the management VLAN, and then re-create the
cluster.
Example
# Specify VLAN 2 as the management VLAN on the current switch.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] management-vlan 2
1.3.20 nm-interface Vlan-interface
Syntax
nm-interface Vlan-interface vlan-id
View
Cluster view
Parameter
vlan-id: ID of the VLAN.
To Next Page
Loading...
