Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Management VLAN Configuration
Commands
Huawei Technologies Proprietary
1-19
1.1.14 interface Vlan-interface
Syntax
interface Vlan-interface vlan-id
undo interface Vlan-interface vlan-id
View
System view
Parameter
vlan-id: ID of the management VLAN, in the range of 1 to 4094.
Description
Use the interface Vlan-interface command to create a management VLAN interface
and enter management VLAN interface view.
Use the undo interface Vlan-interface command to remove the management VLAN
interface.
Before creating a management VLAN interface, make sure the VLAN identified by the
vlan-id argument is created and is configured to be the management VLAN.
Note that:
To configure the management VLAN of a switch operating as a cluster management
device to be a cluster management VLAN (using the management-vlan vlan-id
command) successfully, make sure the vlan-id argument provided in the
management-vlan vlan-id command is consistent with that of the management VLAN.
Example
# Create VLAN 10 and configure it to be the management VLAN. Enter VLAN 10
interface view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] vlan 10
[Quidway-vlan10] quit
[Quidway] management-vlan 10
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10]
1.1.15 ip address
Syntax
ip address ip-address mask [ sub ]
To Next Page
Loading...
Need help?
General