Huawei Quidway S3900 Series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-41
Parameter
priority: Interface priority for electing the "designated router", ranging from 0 to 255. The
default value is 1.
Description
Use the ospf dr-priority command to configure the priority for electing the "designated
router" on an interface.
Use the undo ospf dr-priority command to restore the default value.
The priority of the interface determines the qualification of the interface when the
"designated router" is elected. The interface with higher priority will be preferred when
the election conflict occurs.
Example
# Set the priority of the interface Vlan-interface 10 to 8 during DR election.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf dr-priority 8
3.1.37 ospf mib-binding
Syntax
ospf mib-binding process-id
undo ospf mib-binding
View
System view
Parameter
process-id: OSPF Process ID. It ranges from 1 to 65535 and defaults to 1.
Description
Use the ospf mib-binding command to bind MIB operation to the specified OSPF
process.
Use the undo ospf mib-binding command to restore the default settings.
When OSPF enables the first process, OSPF always binds MIB operation to this
process. You can use this command to bind MIB operation to another OSPF process.
To cancel the binding, use the undo ospf mib-binding command. OSPF will
automatically re-bind MIB operation to the first process that it enables.
By default, MIB operation is bound to the OSPF process enabled first.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English