Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-6
filter-policy route-policy route-policy-name export
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy route-policy route-policy-name export
View
RIP view
Parameter
acl-number: Number of the basic or advanced ACL used to filter routing information by
destination address.
ip-prefix-name: Name of the address ip-prefix list used to filter routing information by
destination address.
route-policy-name: Name of the route-policy used to filter routing information. A
route-policy can enable RIP to determine which routes are to be sent/received based
on such fields as acl/cost/interface/ip/ip-prefix/tag.
routing-protocol: Routing protocol whose routing information is to be filtered. Currently,
this can be direct, ospf, ospf-ase, ospf-nssa, or static.
Description
Use the filter-policy export command to enable RIP to filter the routing information to
be advertised.
Use the undo filter-policy export command to cancel the filtering of the routing
information to be advertised.
By default, RIP does not filter routing information before advertising.
Related command: acl, filter-policy import, ip ip-prefix.
Example
# Configure to filter route information by ACL 2000 before the information is advertised.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] rip
[Quidway-rip] filter-policy 2000 export
2.1.7 filter-policy import
Syntax
filter-policy gateway ip-prefix-name import
undo filter-policy gateway ip-prefix-name import
To Next Page
Loading...
Need help?
General