Huawei Quidway S3900 Series Command Manual

Command Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-18
Parameter
interface-list: Ethernet port list. You can specify multiple Ethernet ports by providing this
argument in the form of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } &<1-10>, where &<1-10> means that you can
provide up to 10 port indexes/port index ranges for this argument.
enable: Enables MSTP on the specified ports.
disable: Disables MSTP on the specified ports.
Description
Use the stp interface command to enable or disable MSTP on specified ports in
system view.
By default, MSTP is enabled on the ports of a switch if MSTP is globally enabled on the
switch, and is disabled on the ports if MSTP is globally disabled.
An MSTP-disabled port does not participate in any calculation of spanning tree and is
always in forwarding state.
Caution:
Disabling MSTP on ports may result in loops.
Related command: stp mode, stp.
Example
# Enable MSTP on Ethernet1/0/1 port in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface Ethernet 1/0/1 enable
1.1.18 stp interface config-digest-snooping
Syntax
stp interface interface-list config-digest-snooping
undo stp interface interface-list config-digest-snooping
View
System view

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English