Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 2 Common IP Multicast Configuration
Commands
Huawei Technologies Proprietary
2-8
group-address: Specifies the group address.
group-mask: Specifies the mask of the group address.
group-mask-length: Specifies the mask length of the group address.
source-address: Specifies the source address.
source-mask: Specifies the mask of the source address.
source-mask-length: Specifies the mask length of the source address.
incoming-interface: Specifies the incoming interface of the forwarding entry.
interface-type interface-number: VLAN interface type and VLAN interface number.
Description
Use the reset multicast forwarding-table command to clear MFC forwarding entries
or the statistics information about MFC forwarding entries.
The order of the group-address argument and the source-address argument can be
turned over. However, you must input valid group addresses and source addresses.
Otherwise, the system prompts error.
Related command: reset pim routing-table, reset multicast routing-table, and
display multicast forwarding-table.
Example
# Clear the forwarding entries whose group address is 225.5.4.3 in the MFC forwarding
table.
<Quidway> reset multicast forwarding-table 225.5.4.3
# Clear the statistics information about the forwarding entries whose group address is
225.5.4.3 in the MFC forwarding table.
<Quidway> reset multicast forwarding-table statistics 225.5.4.3
2.1.8 reset multicast routing-table
Syntax
reset multicast routing-table { all | { group-address [ mask { group-mask |
group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ]
| incoming-interface interface-type interface-number } * }
View
User view
Parameter
all: All routing entries in the multicast core routing table.
group-address: Specifies the group address.
To Next Page
Loading...
Need help?
General