Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-8
2.1.8 host-route
Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Use the host-route command to enable RIP to accept host routes.
Use the undo host-route command to reject host routes.
By default, RIP accepts host routes.
In some special cases, RIP receives a great number of host routes from the same
network segment. These routes are of little help to path searching and occupy a lot of
resources. In this case, the undo host-route command can be used to reject host
routes.
Example
# Enable RIP to reject host routes.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] rip
[Quidway-rip] undo host-route
2.1.9 import-route
Syntax
import-route protocol [ cost value | route-policy route-policy-name ]*
undo import-route protocol
View
RIP view
Parameter
protocol: Source routing protocol whose routes will be imported by RIP. At present, RIP
can import the following types of routes: direct, ospf, ospf-ase, ospf-nssa and static.
To Next Page
Loading...
