Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-21
Example
# Enter cluster view.
<Quidway> system-view
System View: return to User View with Ctrl+Z
[Quidway] cluster
[Quidway-cluster]
1.3.6 cluster enable
Syntax
cluster enable
undo cluster enable
View
System view
Parameter
None
Description
Use the cluster enable command to enable the cluster function on a switch.
Use the undo cluster enable command to disable the cluster function on a switch.
By default, the cluster function is enabled on all the devices supporting cluster.
You need to create a cluster with the build command before using the cluster enable
command on the management device.
These two commands can be used on any device supporting the cluster function.
When you execute the undo cluster enable command on a management device, the
cluster is removed, and the switch stop operating as a management device. When you
execute this command on a member device, the cluster function is disabled on the
switch, and the switch quit the cluster. When you execute this command on a switch
that belongs to no cluster, the cluster function is disabled on the switch.
Example
# Enable the cluster function on a switch.
<Quidway> system-view
System View: return to User View with Ctrl+Z
[Quidway] cluster enable
To Next Page
Loading...
Need help?
General