Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 2 Common IP Multicast Configuration
Commands
Huawei Technologies Proprietary
2-6
View
System view
Parameter
None
Description
Use the multicast routing-enable command to enable the IP multicast routing feature.
Use the undo multicast routing-enable command to disable the IP multicast routing
feature.
The IP multicast routing feature is disabled by default.
Related command: pim dm, pim sm.
Example
# Enable the IP multicast routing feature.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] multicast routing-enable
2.1.6 multicast-source-deny
Syntax
multicast-source-deny [ interface interface-list ]
undo multicast-source-deny [ interface interface-list ]
View
System view, Ethernet port view
Parameter
interface-list: Specifies Ethernet port list, expressed in the form of interface-list =
{ { interface-type interface-num | interface-name } [ to { interface-type interface-num |
interface-name } ] }&<1-10>. The interface-number argument refers to one single
Ethernet port, expressed in the form of interface-number = { interface-type
interface-number | interface-name }, where the interface-type argument refers to the
port type, the interface-number argument refers to the port number, and the
interface-name argument refers to the port name. For meanings and value ranges of
interface-type, interface-number and interface-name, refer to the parameters in the
section “Port Basic Configuration” in this manual.
To Next Page
Loading...
