Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Port Basic Configuration
Commands
Huawei Technologies Proprietary
1-28
Parameter
vlan-id-list: VLAN range to which the trunk port will be added. vlan-id-list = [ vlan-id1 [ to
vlan-id2 ] ]&<1-10>, where, vlan-id is in the range of 1 to 4094 and can be discrete, and
&<1-10> means you can input up to ten VLAN IDs/ID ranges.
all: Adds the trunk port into all VLANs.
Description
Use the port trunk permit vlan command to add the trunk port into the specified
VLAN.
Use the undo port trunk permit vlan command to remove the hybrid port from the
specified VLAN.
A trunk port can belong to multiple VLANs. When you use the command several times,
all VLAN specified in the commands will be allowed to pass the port.
Related command: port link-type.
Example
# Add the trunk port Ethernet1/0/1 to VLAN 2, VLAN 4 and VLAN 50 through VLAN
100.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] port link-type trunk
[Quidway-Ethernet1/0/1] port trunk permit vlan 2 4 50 to 100
Please wait... Done.
1.1.29 port trunk pvid vlan
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet port view
Parameter
vlan-id: VLAN ID defined in IEEE802.1Q, in the range of 1 to 4094. It is 1 by default.
Description
Use the port trunk pvid vlan command to set the default VLAN ID for the trunk port.
Use the undo port trunk pvid command to restore the default setting.
To Next Page
Loading...
Need help?
General