Huawei Quidway S3900 Series - Display Pim Rp-Info

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands
Huawei Technologies Proprietary
6-9
Example
# Display the information about the PIM multicast routing table.
<Quidway> display pim routing-table
PIM-SM Routing Table
Total 0 (*,*,RP)entry, 0 (*,G)entry, 2 (S,G)entries
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
(192.168.1.2, 224.2.181.90),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
Total 2 entries listed
Table 6-4 Description on the fields of the display routing-table command
Field Description
RP Rendezvous Point
(S,G) (source address, multicast group)
PIM-SM PIM Sparse Mode
SPT Shortest Path Tree
RPF Reverse Path Forwarding
6.1.9 display pim rp-info
Syntax
display pim rp-info [ group-address ]
View
Any view
Parameter
group-address: Specifies the group address to display. If no multicast group is specified,
the RP information about all multicast groups will be displayed.