Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510 Chapter 1 HGMPv2 Configuration Commands
Huawei Technologies Proprietary
1-36
Description
Use the nm-interface Vlan-interface command to configure the network management
interface of the management switch.
You can specify the network management interface of the management device, so that
the network administrator can access the management switch through the network
management interface to manage the devices in the cluster.
 Note:
z By default, the network management interface is a management VLAN interface.
z There can be only one network management interface, and the reconfigured
network management interface will replace the old one.
Example
# Configure VLAN-interface 2 as the network management interface.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] cluster
[Quidway-cluster] nm-interface Vlan-interface 2
1.3.21 reboot member
Syntax
reboot member { member-number | mac-address H-H-H } [ eraseflash ]
View
Cluster view
Parameter
member-number: Member number of a switch in a cluster, ranging from 0 to 255.
mac-address H-H-H: MAC address of the member device to be rebooted.
eraseflash: Deletes the configuration file when the member device reboots.
Description
Use the reboot member command to reboot a specified member device on the
management device.
Communication between the management and member devices may be interrupted
due to some configuration errors. Through the remote control function of member
To Next Page
Loading...
Need help?
General