Huawei Quidway S3900 Series - Reset Stop-Accounting-Buffer

Command Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
Huawei Technologies Proprietary
1-71
1.3.12 reset stop-accounting-buffer
Syntax
reset stop-accounting-buffer { hwtacacs-scheme hwtacacs-scheme-name |
session-id session-id | time-range start-time stop-time | user-name user-name }
View
User view
Parameter
hwtacacs-scheme hwtacacs-scheme-name: Configures to delete the
stop-accounting requests from the buffer according to the specified HWTACACS
scheme name. The hwtacacs-scheme-name specifies the HWTACACS scheme
name with a character string of up to 32 characters, excluding forward slashes (/),
colons (:), asterisks (*), question marks (?), less-than signs (<), and greater-than
signs (>).
session-id session-id: Displays information on buffered stop-accounting requests
according to the session ID specified by session-id, a character string of up to 50
characters.
time-range start-time stop-time: Displays information on buffered stop-accounting
requests according to the request time, where, start-time is the start time of the
stop-accounting request; stop-time is the end time of stop-accounting request. This
argument is in the format hh:mm:ss - mm/dd/yyyy or hh:mm:ss-yyyy/mm/dd and is
used to display the buffered stop-accounting requests from the start time to the end
time.
user-name user-name: Displays information on buffered stop-accounting requests
according to the user name specified by user-name, a character string of up to 80
characters, excluding forward slashes (/), colons (:), asterisks (*), question marks (?),
less-than signs (<), and greater-than signs (>). Moreover, “@” can appear no more
than once, and the user name (the part before “@”, the user ID) can not exceed 55
characters; the domain name (the rest part after “@”) cannot exceed 24 characters.
Description
Use the reset stop-accounting-buffer command to clear the stop-accounting
requests that have no response and are buffered on the switch.
Related command: stop-accounting-buffer enable, retry stop-accounting,
display stop-accounting-buffer.
Example
# Delete the buffered stop-accounting requests that are according to the HWTACACS
scheme “hwt1”.