Huawei Quidway S3900 Series Command Manual

Command Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
Huawei Technologies Proprietary
1-67
View
HWTACACS scheme view
Parameter
ip-address: Specified source IP address which cannot be an all-zero address, class D
address or loopback address.
Description
Use the nas-ip command to specify the source address for sending HWTACACS
packets.
Use the undo nas-ip command to restore the default setting.
Note that:
z By specifying the source address of the hwtacacs packet, you can avoid
destination unreachable packets as returned from the server upon interface
failure. The source address is normally recommended to be a loopback interface
address.
z This command specifies only one source address; therefore, the newly
configured source address may overwrite the original one.
Related command: display hwtacacs.
Example
# Set the source IP address of the HWTACACS packets to 10.1.1.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] hwtacacs scheme hwt1
[Quidway-hwtacacs-hwt1] nas-ip 10.1.1.1
1.3.8 primary accounting
Syntax
primary accounting ip-address [ port ]
undo primary accounting
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
By default, the IP address of the primary accounting server is 0.0.0.0.
port: Port number of the server, which is in the range 1 to 65535 and defaults to 49.

Huawei Quidway S3900 Series Specifications

General

Brand	Huawei
Model	Quidway S3900 Series
Category	Switch
Language	English