Command Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
Huawei Technologies Proprietary
1-60
Example
# Set the response timeout time in the RADIUS scheme radius1 to five seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] radius scheme radius1
New Radius scheme
[Quidway-radius-radius1] timer response-timeout 5
1.2.32 user-name-format
Syntax
user-name-format { with-domain | without-domain }
View
RADIUS scheme view
Parameter
with-domain: Specifies to include ISP domain names in the user names to be sent to
RADIUS servers.
without-domain: Specifies to exclude ISP domain names from the user names to be
sent to RADIUS servers.
Description
Use the user-name-format command to set the format of the user names to be sent
to RADIUS server
By default, except for the default RADIUS scheme "system", the user names sent to
RADIUS servers in any RADIUS scheme carry ISP domain names.
Note that:
z Generally, an access user is named in the userid@isp-name format. Where,
isp-name behind the @ character represents the ISP domain name, by which the
device determines which ISP domain it should ascribe the user to. However,
some old RADIUS servers cannot accept the user names that carry ISP domain
names. In this case, it is necessary to remove the domain names carried in the
user names before sending the user names to the RADIUS server. For this
reason, the user-name-format command is designed for you to specify whether
or not ISP domain names are carried in the user names sent to the RADIUS
server.
z For a RADIUS scheme, if you have specified that no ISP domain names are
carried in the user names, you should not use this RADIUS scheme in more than
one ISP domain. Otherwise, such errors may occur: the RADIUS server regards
To Next Page
Loading...
